Difference Between Point Hanging and Dry Hanging for Tiles

The point placing and dry putting of tiles are extraordinary, and interest to element is essential to make certain right use later on. So what's the difference between factor striking and dry hanging of tiles?

The Differences Between Tile Dot Hanging and Dry Hanging：

1. point putting of tiles does no longer require drilling holes within the stone, whereas dry hanging requires drilling holes in each the again and facet of the stone.

2. factor hanging of tiles requires the use of attitude brackets for fixation, while dry placing uses iron wires or copper wires to assist the stone.

3. point striking of tiles has strict necessities, with the original shape wanting to be a concrete wall, and there are boundaries on space. In assessment, dry hanging does now not have such strict necessities.

What information should be cited for factor striking of tiles：

1. before laying tiles, the substrate should be wiped clean well. If the wall has any decorations like paint, latex paint, or wallpaper, or if there may be dust on the ground, it need to be cleaned very well. in any other case, the cement and mortar layer might not adhere firmly.

2. before putting in the tiles, an adhesive ought to be applied to the lower back of the tiles. this will use greater materials, but it may make certain universal high-quality and sturdiness.

3. For ground tiles, there is a tip and a rule: attempt to lay the tiles from the inside out, which facilitates reasonable placement and is beneficial for the slope layout of the drainage. determine the slope in line with the drainage direction, and wall tiles should be started from the bottom. for classy motives, the bottom tiles should be adhered later. After the wall tiles are hooked up, they ought to press down on the floor tiles. whilst the usage of half tiles, they have to be located at the lowest as a great deal as feasible. additionally, do now not try to lay an entire wall from the top to avoid the danger of the heavy tiles collapsing.

4. The moisture content of wall tiles is excessive, so this need to be considered throughout installation. the base layer must be thoroughly watered and moistened before laying mosaics, and the mosaics have to soak in water for as a minimum 20 hours before use.

In precis：that is an creation to the difference among factor hanging and dry placing of tiles. i am hoping absolutely everyone has a better information. factor hanging and dry striking of tiles are distinctive, and distinguishing between the 2 in advance is useful for next normal use and avoids needless troubles.