Home / Blog Center / Chargers / How to Connect the 6 Wires of a Warm Wind Bath Heater

How to Connect the 6 Wires of a Warm Wind Bath Heater

07/01/2025 | Hawkrown

How to connect the six wires of a warm air bath heater? As a non-professional wiring person, you may not be very familiar with this. But don't worry, let's explore this together!

How to connect a six-wire warm air bath heater

If you're not a professional in wiring warm air bath heaters, you might not be familiar with how to connect the wires. But don’t worry, let’s learn together!

How to connect a six-wire warm air bath heater

First, turn off the main power switch. Connect the neutral wire of the bath heater to the neutral wire of the 220V power supply. The live wire of the 220V power supply should be connected to one of the three paired terminals of the bath heater switch (out of the six terminals on the switch, three terminals are connected in pairs, and the incoming live wire is connected to these). The remaining three terminals should be connected to the other two bath heater lights and one ceiling light. Once everything is connected, turn on the power. Remember, the neutral wire of the bath heater should always be connected to the neutral wire of the 220V power supply, which is usually the black wire.

Standards for connecting a warm air bath heater

1. The connections of the wires must be secure and reliable, with good electrical contact, sufficient mechanical strength, and resistance to corrosion and oxidation. Additionally, the insulation performance should be excellent.

2. Before starting the wiring, carefully examine the instructions or the electrical wiring diagram inside the machine. Only after understanding the circuit should you begin the wiring process.

3. The stripped ends of the wires for the switch and terminal blocks should be between 6mm and 10mm. The lengths of other stripped wire ends should depend on specific requirements. The wire ends for the switch should not be too long—generally not exceeding 100mm. If they are too long, trim the excess. After completing the switch wiring, try to push the wires into the conduit and organize them before fixing the switch.

4. Whether dealing with single-stranded or multi-stranded wires, when inserting the wire ends into the switch and terminal block, pay attention to two points: first, the wires must be fully inserted; second, do not insert the insulation layer into the terminal holes. The exposed bare wire beyond the insulation should not exceed 3mm.

5. The same terminal can connect to two wires of the same type and specification.

In conclusion:after reading the above introduction, you should have a better understanding of how to connect a warm air bath heater with six wires. If you want to learn more related information, please continue to follow our website, as we will present more exciting content in the future.

Contact Us

Submission Successful

ok