Can a Washing Machine and Toilet Share a Water Supply?

In water supply development, is it conceivable to share a single water supply line for both a washing machine and a latrine? Here, I will give a brief presentation to this point.

Can a washing machine and a can share a water supply line?

Yes, it's conceivable. You'll be able introduce a T-joint on the water supply line and interface it to both the latrine and the washing machine. For the most part, the water weight within the metropolitan water channels is tall sufficient that the washing machine can fill with water whereas the can flushes at the same time without influencing every day utilize. When sharing a water supply line, it is prudent to have the washing machine's channel valve situated higher than the can tank or to install a check valve at the can. This way, within the occasion of a water supply intrusion, the water within the can tank will not backflow.

What ought to be famous amid domestic water supply construction?

1. During water supply development, it's basic to guarantee that hot and cold water channels don't run within the same conduit or are as well near together. In the event that the hot water pipe is in near vicinity to the cold water pipe, it may influence the cover of the hot water line. There ought to be a crevice of at slightest 10 centimeters between hot and cold water channels. In case there isn't sufficient cold water channeling, you'll be able use hot water channels as a substitute, but hot water channels ought to never be supplanted with cold water channels. Cold water channels have lower warm resistance and more slender dividers, making them more powerless to splitting and spills.

2. When building water channels, dodge interfacing all outlets to a single water line over long separations. The water weight at the conclusion of a long water pipe will be lower and may influence water utilization. It is superior to branch off different lines from the most water supply line to maintain superior water weight. Moreover, guarantee that the specifications of the department lines are littler than those of the most supply line amid development.

3. After completing water supply development, don't instantly seal and fill the grooves. To begin with, conduct a weight test to check for spills. The testing weight for water channels is for the most part between 8 and 10 kilograms, and the weight ought to stay steady for 30 minutes without dropping more than 0.5 kilograms. In the event that spills are found, find and repair the spill instantly.

In outline：usually a basic presentation to whether a washing machine and a latrine can share a water supply line. I trust this article gives reference and help. For more related data, if it's not too much trouble proceed to take after our site.